LPAR2RRD and STOR2RRD Virtual Appliance

You can use VMware or Microsoft Hyper-V image for fast start or for product evaluation purposes.
It contains installed and configured LPAR2RRD and STOR2RRD products with all their prerequisites.
It is distributed in OVF or Hyper-V format easily importable in your infrastructure

current image.

Image installation and configuration instructions: LPAR2RRD
Image installation and configuration instructions: STOR2RRD

Getting started

Virtual Appliance can be installed:

• As a virtual machine in your vCenter or ESXi
• On VMware player. A free non-commercial version.
• As a virtual machine in your Microsoft Hyper-V server

Acquired IP address is printed out on the console after the appliance starts up.
Navigate your web browser to the address shown on the welcoming screen.
http://<appliance IP>/

Product webs are accessible with this credentials:

WEB user	admin (user "monitor" was used on Virtual Appliances v1.x)
Password	<password can be found in the pdf document distributed together with the image>
Sites:	http://<appliance IP>/lpar2rrd , http://<appliance IP>/stor2rrd

System defaults

Operating System	CentOS 7, 64bit
root	<password can be found in the pdf document distributed together with the image>
lpar2rrd	<password can be found in the pdf document distributed together with the image>
IP address	DHCP

Virtual machine settings

Processors	2
Memory	6GB
Hard-drive	100GB (thin provisioned)
Network	Bridged (using DHCP)
VMware Tools installed (VMware image only)

The VMware image should work on recent VMware products as well on other virtualization software that support OVF (Open Virtualization Format). The image has been successfully installed on at least:

• VMware player 6
• VMware ESX 4.1

Recommended HW sizing:

• Evaluation purposes:
• 6GB RAM
• 2 CPU
• 100GB disk space (thin provisioning)
• Production with 1000 VMs and 10 storages
• 12GB RAM
• 4 CPUs
• 100GB disk space (thin provisioning)